美国混凝土协会期刊
期刊
会议
图书
作者:Sidney Mindess , Daniel St.-Pierre ...
来源:[J].Structural Journal(IF 0.806), 1997, Vol.94 (1)ACI
摘要:This paper summarizes all available previous shear tests on fiber reinforced concrete beams without stirrups, and presents the results from 11 large-scale beam element tests. The beams had an overall depth of 610 mm (effective depth of 560 mm), and were constructed with varying a...
作者:... Nemkumar Banthia , Sidney Mindess
来源:[J].Materials Journal(IF 0.826), 1999, Vol.96 (3)ACI
摘要:Shotcrete is produced by concrete constituents being projected against a shooting surface. However, due to the high velocities developed, it is impossible to observe in-flight particles using conventional tools. As a result, the state of the art on shotcrete kinematics shows a ge...
作者:... Homayoun Hosseini Abrishami , Sidney Mindess
来源:[J].Materials Journal(IF 0.826), 1996, Vol.93 (1)ACI
摘要:This paper presents the tensile behavior of 12 concrete members, each reinforced with one No. 1.5 bar: The variables included normal- versus high-strength concrete, with and without steel fibers and with and without epoxy coating. In addition, two different thicknesses of epoxy c...
作者:Sidney Mindess , J. - .F Trc
来源:[J].Materials Journal(IF 0.826), 1996, Vol.93 (5)ACI
摘要:Concrete in many civil engineering structures must have adequate resistance to impact and impulsively applied loads. Unfortunately, our understanding of the behavior of concrete to impact loads is far from adequate and there is significant variability in the published literature....
作者:Sidney Mindess , Takeshi Ishibashi
来源:[J].Materials Journal(IF 0.826), 2003, Vol.100 (3)ACI
摘要:This study investigates the effect of loading rate on the ultimate pullout resistance of chemically bonded anchors subjected to rapid tensile load. It is well known that when the anchor bolt itself has enough strength, a chemically bonded anchor subjected to tensile loading usual...
作者:Pierre-Claude A�tcin , Sidney Mindess
来源:[J].Concrete International, 2015, Vol.37 (5)ACI
摘要:For many years, the North American cement industry was well served by the so-called Type I/II cements. This type of cement had C3A contents below 6.5%. While concrete produced with this cement did not exhibit high early strength, it did exhibit good durability. The cement industr...
作者:... Dudley Morgan , Sidney Mindess
来源:[J].Materials Journal, 2016, Vol.113 (3)ACI
摘要:The question is sometimes asked: “How does the durability of shotcrete compare to that of cast-in-place concrete?” The durability of shotcrete and concrete structures is strongly influenced by their transport properties. While considerable data are available regarding the tr...
作者:... Denis Beaupre , Sidney Mindess
来源:[J].Concrete International, 2002, Vol.24 (10)ACI
摘要:This paper describes the development, the use and the benefits of an apparatus intended to measure the in-place consistency of dry process shotcrete. The effects of consistency on the in-place properties of fresh shotcrete (composition, rebound, viscosity) are presented. Dependin...
作者:Sidney Mindess , Jean-Claude Roumain ...
来源:[J].Concrete International, 2006, Vol.28 (8)ACI
摘要:Prescriptive specifications for concrete have served us reasonably well in the past, but they tend to inhibit the most efficient use of currently available materials and are far from a guarantee of concrete durability. Moving to performance-based specifications could enable concr...

我们正在为您处理中,这可能需要一些时间,请稍等。

资源合作:cnki.scholar@cnki.net, +86-10-82896619   意见反馈:scholar@cnki.net

×