全部文献期刊学位论文会议报纸专利标准年鉴图书|学者科研项目
中外文文献  中文文献  外文文献
作者:Kwan-Sik Yang , Hideto Yoshida
来源:[J].Separation and Purification Technology(IF 2.894), 2003, Vol.37 (3), pp.221-230Elsevier
摘要:Abstract(#br)Experimental and simulation studies have been conducted about the effect of mist injection position on particle separation performance of cyclone scrubber.(#br)The typical particle trajectories for the normal type cyclone are calculated. The optimum mist injection po...
作者:Jin Wang , Qianqian Li , Bengt Sundén ...
来源:[J].Journal of Environmental Management(IF 3.057), 2017Elsevier
摘要:... Cases with 1% mist injection were also included in order to obtain better cooling performance. Results show that the bulge configuration located upstream the film hole makes the cooling film more uniform, and enhanceslateral cooling effectiveness. Unlike other cases, the conf...
作者:Aqiang Lin , Yonggang Sun , Hai Zhang ...
来源:[J].Applied Thermal Engineering(IF 2.127), 2018, Vol.142, pp.779-792Elsevier
摘要:Abstract(#br)A feasible method of injecting water mist into the air can improve the operation performance of gas turbine. This study aims to develop a deeper understanding of aerodynamic characteristics of fluctuating quantities and its influence caused by air-mist two phase...
作者:Aqiang Lin , Qun Zheng , Yuting Jiang ...
来源:[J].International Journal of Heat and Mass Transfer(IF 2.315), 2019, Vol.137, pp.882-894Elsevier
摘要:Abstract(#br)A comparative study of performance characteristics in a gas turbine compressor before and after water injection into the air is carried out to explore the relationships between the transient characteristic and mist injection. The Eulerian-Lagrangian particle track...
作者:Ke Tian , Jin Wang , Chao Liu ...
来源:[J].Energy(IF 3.651), 2018, Vol.153, pp.661-670Elsevier
摘要:... In addition, mist injection with three droplet sizes (1 μm, 5 μm and 10 μm) is also considered. It is found that the position of the blockage configuration shows almost no influence on the cooling performance. In addition, the hemispherical blockage configuration results ...
作者:Jin Wang , Pei Cui , Bengt Sundén ...
来源:[J].Numerical Heat Transfer, Part A: Applications(IF 1.803), 2016, Vol.70 (10), pp.1072-1086Taylor & Francis
摘要:... For no-mist models, the cooling performances downstream the wall are investigated for the blowing ratios of 0.5, 0.75, and 1.0. Results show that the adiabatic film-cooling effectiveness without surface deposition is decreased by increasing the blowing ratio. To investig...
作者:Jin Wang , Ke Tian , Kai Zhang ...
来源:[J].Thermal Science(IF 0.838), 2018, Vol.22 (5), pp.1933-1942塞尔维亚热力工程师协会
摘要:... In addition, water droplets are also released from the coolant inlet to provide a comparison of the results with and without mist injection. It is found that the lateral film cooling effectiveness is reduced with increasing blockage ratio. For all the cases with the blowing r...
作者:Ke Tian , Jin Wang , Chao Liu ...
来源:[J].Thermal Science(IF 0.838), 2018, Vol.22 (5), pp.1923-1931塞尔维亚热力工程师协会
摘要:... In addition, the film cooling with mist injection also provides a significant enhancement on cooling performance especially for the combined hole case with a small droplet size (10−5 m).
作者:Homayoon Kanani , Mehrzad Shams , Reza Ebrahimi
来源:[J].Heat and Mass Transfer(IF 0.84), 2009, Vol.45 (6), pp.727-741Springer
摘要:...16, were employed to calculate the gas and droplet flows and film cooling effectiveness with and without mist on a flat plate. Two different three dimensional geometries are generated and the effects of the geometrical shape, size of droplets, mist concentration in the coo...
作者:Jiang, Yuting , Zheng, Qun , Yue, Guoqiang ...
来源:[J].Proceedings of the Institution of Mechanical Engineers(IF 0.633), 2014, Vol.228 (15)ProQuest
摘要:... On the basis of it, the mist cooling is simulated under typical gas turbine operating conditions for internal convective cooling to discuss the improvement of cooling performance. Though the results indicate that mist cooling can decrease the temperature of boundary layer wit...

我们正在为您处理中,这可能需要一些时间,请稍等。

资源合作:cnki.scholar@cnki.net, +86-10-82896619   意见反馈:scholar@cnki.net

×